RS11
RS11
Description | Performance Requirements | Test Method | |||
---|---|---|---|---|---|
Resistance Temperature Coefficient | (Resistance Range) | (Maximum Resistance Value Range) | Test Temperature | ||
-55~+20°C | +20~°C +100°C | +20°C/-55°C/+20°C/+100°C/+20°C | |||
≦1KΩ | ±6.5 | ±5.0 | |||
1.1KΩ~10KΩ | ±10 | ±6.0 | |||
11KΩ~100KΩ | ±13 | ±7.5 | |||
110KΩ~1MΩ | ±15 | ±10 | |||
1.1MΩ~10MΩ | ±20 | ±15 | |||
≧11MΩ | ±25 | ±20 | |||
Voltage Coefficient | ≦±0.035%/V | use 10% and 100% rated voltage or maximum voltage (the lower) to test resistance value | |||
Short-time Over load | △R≦2.5%R | 2.5time rated voltage or maximum over lad voltage (the lower)5 seconds | |||
Wlith Standing Voltage | No flasheover or breakcown | Testing voltage 100v 1 minute | |||
Terminal Strength | Pulled | △R≦±2%R No Visible damage |
Φd 0.6mm:Load 10N 10s | ||
Winded | Φd 0.6mm:Load 10N 90° | ||||
Twisted | 360°in opposite direction | ||||
Resistance to Vibration | R≦±2% No visible damage | 3 direction 2 hours each | |||
Solder-neat Resistance | △R≦±2%R Marks legible, no bisible damage | 4mm from the body.3 seconds | |||
Solder ability | At least 95% of the dipping surface must be covered by new solder, no flaws gather ed. | 2 mm from the body. 2 seconds | |||
Temperature Cyfcle | R≦±2% No visible damage | -55/+85℃ For 5 cycles | |||
Humidity | R≦±10% No visible damage | 40℃ 95%RH 240 hours | |||
70°C(Load Life) | R≦±10% No visible damage Marks legible | Rated voltage or maximum voltage,1.5 hours on, 0.5 hours off, 70 centigrade temperature 1000 hours |